Quest Engineering M Series Owner's Manual page 6

M35bt / M65bt
1. Input Channel Volume – These three knobs determine the level of the sound sources connected to the
inputs.
2. Tone Control – These two knobs adjust the overall frequency response of the system. They allow up to 10dB
of cut/boost on the 100Hz and 10kHz bands.
3. Master Volume Control – This knob determines the overall volume of the system.
4. Indicators (3) – The "Protect" indicator lights when the protection circuit is activated. The outputs are then
deactivated. The "Signal, -20dB and Clip" LEDs indicate the output level. The "Power" indicator lights up
when the device is powered on and ready for use.
5. POWER switch - This switch turns the device on/off. The POWER indicator lights up when the power is on.
6. Bluetooth/FM Receiver and MP3 Player – This module includes Bluetooth, an FM receiver with memories
and an MP3 player on SD/SDHC card and USB port. The M35bt, and M65bt are shipped with an
infrared remote control.
7. AUX input
[Figure 1.1 Front panel diagram]
M-Series – Front Panel Presentation
4