CareCo BA09023 Quick Start Manual

Bathboard with swivel seat

Thank you for purchasing the Bathboard and Swivel Seat from CareCo, we hope you are pleased

with your purchase.

A 1x

B 3x

F 1x

ASSEMBLY

Ensure all parts are present and remove all packaging

Push the red transfer handle into the two holes at the end of the

bathboard with the handle angled towards the bathboard.

BA09023 – Bathboard with Swivel Seat

C 4x

D 4x

E 4x

G 1x

A 1x Bathboard

B 3x Plastic Bolt (Circular)

C 4x Plastic Bolt (Rectangular)

D 4x Bath board feet

E 4x Plastic Washer

F 1x Transfer Handle

G 1x Swivel Seat

Table of Contents

Do you have a question about the BA09023 and is the answer not in the manual?

Page 1 BA09023 – Bathboard with Swivel Seat Thank you for purchasing the Bathboard and Swivel Seat from CareCo, we hope you are pleased with your purchase. A 1x A 1x Bathboard B 3x Plastic Bolt (Circular) C 4x Plastic Bolt (Rectangular)
Page 2 Using the rectangular plastic bolts and washers, secure the four feet to the underside of the bathboard. The bolt goes through the surface of the bathboard, through a washer on the underside and then screws into the feet. Place the blue swivel disc into the hole in the middle of the bathboard. Whilst holding in place, use the circular bolt to secure in place from the underside.
Page 3 This warranty expresses our confidence in workmanship and materials used for our products. In the event of a defect covered by this warranty, CareCo will, at our discretion, replace the wheelchair or provide parts to remedy. This warranty does not cover device failure due to owner misuse or negligence, or due to normal wear and tear.
Page 4 CareCo, Hubert Road, Brentwood, Essex CM14 4JE www.careco.co.uk...