paco LBC1205 Instruction Manual page 13

11. CHASSIS EARTHING
The chassis earthing lug should be connected to an earting point which will be
depending on where the battery charger is installed In a vehicle, connect the
chassis ground lug to the chassis of the vehicle. In a boat, connect to the boat's
grounding systems. In a fixed location, connect to earth.
8-STAGE LiFePO CHARGING
4
P/No.: LBC 1220
INPUT: 220-240V AC, 50/60Hz, 554W
OUTPUT: 12V DC, 20,000mA
FUSE: T5A, 250V AC
OUTPUT
12V DC
STEP 3 – CONNECT TO 110V/220-240V AC MAINS POWER
Connect the battery charger to the 110V/220-240V AC mains powered socket and
turn on the mains power.
STEP 4 – CHARGING
During the charge process, the CHARGING and STAGE LAMP will flash various
patterns. This is normal and indicates the various charge stages. Refer to "How can
I know what stage the battery charger is in" in the charge status indicator section,
page 6.
When the STAGE LAMP remains on, this is known as the float stage and the charger
can be left connected to the battery without over charging.
If the POWER ON LAMP is flashing, there is fault; refer to "Fault Codes" explanation
on page 16 of this manual.
STEP 5– DISCONNECTION
Ensure the 110V/220-240V AC mains switch is turned off and the charger is
disconnected from the 110V/220-240V AC mains power.
Battery out of vehicle
Remove the BLACK lead (battery clip) from the battery.
Remove the RED lead (battery clip) from battery.
Battery in vehicle
Remove the chassis connection.
Remove the battery terminal connection.
FAN
INPUT
AC
CHASSIS
GND
12