Advertisement
Quick Links
Advertisement
Related Manuals for OZTENT AT-6
Summary of Contents for OZTENT AT-6
- Page 1 AT-6 AIR TENT OZ01TEATA OWNER’S MANUAL...
- Page 2 Oztent Australia Pty Ltd www.oztent.com Document No. June 2022 Prepared by: Product Department Authorised by: Richard Channing Issue No. 0003 Issue date: 25/10/2022 © Oztent Australia Pty Ltd March 2022 - All rights reserved Page 1 of 12...
- Page 3 Congratulations and thank you for choosing your new Oztent product. We are sure that you will find your new Oztent product a pleasure to use and enjoy. Before setup or use, we recommend that you read through this entire manual. It provides full user instructions.
-
Page 4: Table Of Contents
OZTENT AT-4/AT-6 Carry Bag OZ02TECBA OZTENT AT-4/AT-6 Air Pump OZ01ACATPA OZTENT Pegs OZPEG OZTENT Sand Pegs OZ01ACSPA OZTENT AT-6 Side Door Pole OZ01TEPOA OZTENT AT-6 Front Pole OZ02TEPOA OZTENT Zip-In Tarp Extension OZ01SPEXA OZTENT Aluminium Telescopic TPOLE323 3 Stage Upright Pole 2.3m... -
Page 5: Warning
AT-6 Air Tent Owner’s Manual Warning Never use any fuel-burning products (stoves, lanterns, heaters, etc.) inside or within proximity of the Tent. Use of fuel-burning products inside or within proximity of the Tent can result in the accumulation of dangerous concentrations of carbon monoxide –... - Page 6 CAMPSITE CHOICE When choosing a campsite, carefully consider the possibility of falling rocks or tree limbs, lightning, flash floods, avalanches, strong winds, and other potential hazards, to reduce the risk of loss or injury. Select a site that’s level, well drained, and is protected from the wind and other elements.
- Page 7 INFLATABLE FRAME The frame of The OZTENT AT-6 Air Tent is composed of inflatable poles. These inflatable poles are in zippered covers and are easy to replace. The poles are made from wear resistant polyurethane (TPU). For additional protection against bursting each pole is protected by a zippered high-resistance polyethylene cover.
-
Page 8: Tent Setup
Tent Setup Step 1: Step 2: Lay the tent out flat on even ground Connect the pump and inflate the and peg the 4 corner loops of the tent poles in the order shown below: to the ground. Step 3: Step 4: Once inflated peg the remaining peg Insert the longer pole through the pole... - Page 9 AT-6 Air Tent Owner’s Manual Tent Setup Step 7: Step 8: Peg all the remaining guy ropes to the Attach the zip in tarp extension, then ground using the pegs provided. extend the poles before pegging the guy ropes tightly.
-
Page 10: Pump And Inflation Guidelines
Pump and Inflation Guidelines: VALVES HAND PUMP The inflation valves are located at the Each tent is supplied with a double-action end of each pole on the outside of the hand pump which can inflate and deflate. tent. These are no-return valves to make inflation easier. -
Page 11: Warranty
To the extent permitted by law, the liability of in Australia, USA or International markets and is in addition Oztent (if any) arising out of or in relation to the Product or any services supplied by Oztent shall be limited (where it is fair and... - Page 12 Oztent Australia Pty Ltd PO Box Q1700 Sydney NSW 2000 Australia Ph: 02 8706 5100 USA Ph: 855 569 8368 International Ph: +61 2 8706 5100 www.oztent.com...
Need help?
Do you have a question about the AT-6 and is the answer not in the manual?
Questions and answers