Page 3
Congratulations and thank you for choosing your new Oztent product. We are sure that you will find your new Oztent product a pleasure to use and enjoy. Before set-up or use, we recommend that you read through this entire manual. It provides full user instructions.
Contents Package Contents ............................3 Warning & Important Information ......................4 Safety and Care ............................5 Setting Up the Oztent RS-1 ........................7 Setting up the awning ..........................9 Parts Identification ............................. 10 Warranty ................................11 Package Contents Item General Part Name RS-1 King Single Swag...
RS-1 King Single Swag Owner’s Manual Warning Never use any fuel-burning products (stoves, lanterns, heaters, etc.) inside or within proximity of this product. Use of fuel-burning inside or within proximity of this product can result in the accumulation of dangerous concentrations of carbon monoxide - a colourless, odourless gas.
Safety and Care Considerations Set-up your swag It is important that you set up your swag when it’s new and also after long periods of storage. This ensures that you are familiar with the set-up process and ensures that all frames, poles and pegs are present and still working correctly.
Page 7
Swag to the ground and swing in arm “A” followed by arm “B”. Always swing the arms low to the ground. 2. The Oztent RS-1 King Single Swag is designed for one person operation. 3. The following illustrations are artistic representations of the Oztent RS-1 King Single Swag and may vary from the production model.
Setting up the Oztent RS-1 Step 1: Take the Swag out of the bag. Place the poles and pegs away from the Swag space. Step 2: Swing out both arms one at a time. Page 7 of 14...
Page 9
RS-1 King Single Swag Owner’s Manual Setting up the Oztent RS-1 Step 3: Pull the Swag up using the swing tab found near the top frame Step 4: Reach inside the Swag and lock the sliding/bracing arms in place, by pushing them up.
Setting up the Oztent RS-1 Step 5: Adjust the Swag so it sits properly. Hammer in all pegs. Peg out guy ropes at 45 degree angle to secure the swag. Step 6: Place the RS-1 Swag mattress inside the Swag. Position it within the frame at the base of the Swag.
RS-1 King Single Swag Owner’s Manual Parts Identification Item General Part Name Part No. Main Extrusion OZME Hinge Corner Foot fitting OZFF Foot M8 Nut, Washer and Slider Brace Extrusion with Fittings RS1SA Page 10 of 14...
To the extent permitted by law, the liability of This warranty only applies to Products purchased and used Oztent (if any) arising out of or in relation to the Product or any in Australia, USA or International markets and is in addition...
Page 13
Oztent Australia Pty Ltd PO Box Q1700 Sydney NSW 2000 Australia Ph: 02 8706 5100 USA Ph: 855 569 8368 International Ph: +61 2 8706 5100 www.oztent.com...
Need help?
Do you have a question about the RS-1 King Single Swag II Series and is the answer not in the manual?
Questions and answers