Firmware Upload Port; Figure 5-6 Firmware Upload Port; Table 5-10 Gds Adaptor Cable Assembly - FutureLogic Gen2 Universal PSA-66-ST2RU Operator's Manual

Item
# Qty
1 1 170-00267-100
2 2 170-00172-100
3 1 170-00269-100
4 1 170-00149-100
5 1 170-00152-100
6 .28 513-00061-100
7 .28 513-00062-100

Firmware Upload Port

The Firmware Upload Port upgrades the printer firmware while the printer is installed and powered
in the game. The printer uploads through its Firmware Upload Port just as it would through its
communications connector at the rear of the printer.
To use this port, slide the printer out until the upload port (shown in the following figure) is visible.
Then plug an appropriate upgrade cable into the printer. This connection may be made while the
power is on.
Figure 5-6 Firmware Upload Port
ã 2006 – 2013 FutureLogic, Incorporated. All Rights Reserved.
Table 5-10
FL. Part #
Conn, 14 Ckt, 2x7, 4.20MM Pitch
Term, Crimp, Female, 18-24AWG,
4.20MM Pitch
Conn, 4 Ckt, 1x4, 4.20MM. Pitch,
Free Hanging
Term, Crimp, Male, 18-24AWG
Term, Crimp, Male, 18-24AWG,
Grounding Pin
Wire Stranded, 20 AWG, Red, 1 Ft.
Wire Stranded, 20 AWG, Black, 1 Ft.
GDS Adaptor Cable Assembly
Description
Firmware Upload Port
Connector: Molex 6717101-000
Mate:
Operators and Technicians Manual
OEM OEM Part #
Molex 39-01-2145
Molex 39-00-0038
Molex 39-01-4046
Molex 39-00-0040
Molex 30490-2002
Belden 9982-2
Belden 9982-10
USB B Plug
MNL Page 17 04/29/2013
MNL-000032 REV.D