Page 1
(FROM THE LABEL ON THE FRONT OR TOP OF THE BOX) this product are a safety critical part of your shower. Failure to use genuine Triton parts may cause injury and invalidate your guarantee. ALTERNATIVELY REGISTER BY TEL: 024 7637 8321...
GUARANTEE, SERVICE POLICY, ETC.......... rear cover NSTALLERS PLEASE NOTE THESE INSTRUCTIONS ARE TO BE LEFT WITH THE USER To check the product suitability for commercial and multiple installations, please contact Triton’s specification advisory service before installation. Please see back of book for contact information.
Water Temperature Requirements Maximum hot water temperature: = 80°C This book contains all the necessary fitting and operating instructions for your Triton mixer Recommended maximum: = 65°C shower. Please read them carefully and read through the whole of this book before beginning Minimum hot water temperature: = 52°C...
Page 5
(above 200-ppm temporary hardness), a scale inhibitor may DO NOT solder fittings near the mixer unit have to be fitted. For advice on the Triton as heat can transfer along the pipework and scale inhibitor, please contact Customer damage the mixer valve.
Bath shower mixer Domestic Gravity Fed Systems (fig.2) *Fig.2 *Diagrammatic view – not to scale. *Fig.2 (diagrammatic view – not to scale) For illustration purposes only. The bath shower mixer MUST be fed from a cold water cistern and hot water cylinder providing Stop valve nominally equal pressures.
Page 7
Bath shower mixer Instantaneous Gas-heated Systems, *Fig.4 *Diagrammatic view – not to scale. e.g. combination boilers (fig.4) For illustration purposes only. The bath shower mixer MUST be installed with a multi-point gas water heater or combination boiler of a fully modulating design i.e. to maintain relatively stable hot water temperatures.
Page 8
Bath shower mixer Mains Pressurised Thermal Store Systems *Diagrammatic view – not to scale. *Fig.5 fig.5) For illustration purposes only. Packages of this type, fitted with a tempering valve (blender valve) can be used. An expansion vessel MUST be fitted and regularly maintained to ensure the unit is not damaged by excess pressures.
Bath shower mixer INSTALLATION *Diagrammatic view – not to scale. *Fig.6 For illustration purposes only. PREPARING THE MIXER SHOWER Check the contents to make sure all parts are present. Before starting the mixer installation, make sure all the openings on the valve are carefully covered to stop ingress of any debris etc.
Bath shower mixer OPERATING THE BATH SHOWER MIXER Fig.13 To start the bath shower mixer rotate either Pull up or both the hot (clockwise for flow) and cold and rotate (anti-clockwise for flow) controls, adjusting each in either individually to achieve the desired showering direction temperature.
Need help?
Do you have a question about the 86004810 and is the answer not in the manual?
Questions and answers