Life Fitness ELEVATION DISCOVER SI Assembly Manual page 7

Lower Frame: How To's
REPLACEMENT OF TOP MOTOR SHROUD COVER
1. Remove and save the six Phillips screws that secure the top motor
shroud cover to the motor cover mounting brackets and frame.
2. Install the new top motor shroud cover using the Phillips screws
saved in Step 1.
REPLACEMENT OF UPRIGHTS
1. Turn the treadmill power switch off.
2. Unplug the line cord from the wall outlet.
3. Remove the top motor cover.
4. Remove either right or left upright shroud depending on which
upright is being replaced.
Remove the inside handrail covers (See
5.
6. Remove the Activity Zone assembly (See
7. Remove the outer handrail covers (See
8. Remove the lower bridge cover (See
9. Remove and save the six upper bolts (three per upright) that secure
the bridge to the uprights.
10. Cables run through both of the uprights. Determining which cable
will be disconnected will depend on which upright is being replaced.
If replacing the left upright, this will require disconnecting the power
cables to the attachable TV and re-routing them through the new
upright. The transformer cable must be removed and rerouted if the
left upright is being replaced.
11. Carefully lift the bridge frame assembly up and out of the uprights
and set it to the side.
12. Remove and save the three lower bolts that secure the upright to
the base frame.
13. Install the new upright using the hardware removed in the previous
steps.
UF 3)
CA 22).
UF 5).
UF 4).
6
Bridge Left Upright
25-35 lb*in
[29-40 kg*cm]
Right Upright