Page 2
If any abnormalities are detected, the system will transmit signals from the tire valve sensors to the wireless receiver. Power is transmitted to the Tire Linc® via a 12V Power Connector that plugs into a constant 12V power source.
Page 3
Programming Procedure on page 4 in place of step number 5. Using the Tire Linc LF Initiator (Fig. 9), go to the left front tire (roadside front) and press and hold the button (Fig. 9A) for 3 seconds on the initiator to sync the left front sensor to the receiver. The receiver (Fig. 6) will then display “config L REAR”...
Page 4
Note: If the Alternate Programming Method below is used, make sure to check the tire pressure to assure the tires are properly inflated. Note: When tires are rotated, the Tire Linc receiver (Fig. 6) must be re-programmed starting from Step 1. Fig. 14 Fig.
Page 6
The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (“LCI”). LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty. ...
Need help?
Do you have a question about the Tire Linc and is the answer not in the manual?
Questions and answers