Cisco Unified Ip Phone Deployment - Cisco 6901 Manual

Cisco Unified IP Phone Deployment

Cisco Unified IP Phone Deployment
When deploying a new IP telephony system, system administrators and network administrators must complete
several initial configuration tasks to prepare the network for IP telephony service. For information and a
checklist for setting up and configuring a Cisco IP telephony network, see the "System Configuration Overview
"chapter in Cisco Unified Communications Manager System Guide.
After you set up the IP telephony system and configure system-wide features in Cisco Unified Communications
Manager, you can add IP Phones to the system.
Cisco Unified IP Phones Setup in Cisco Unified Communications Manager
To add phones to the Cisco Unified Communications Manager database, you can use:
• Autoregistration: Not supported if Cisco Unified Communications Manager operates in mixed mode.
• Cisco Unified Communications Manager
• Bulk Administration Tool (BAT)
• BAT and the Tool for Auto-Registered Phones Support (TAPS)
For general information about configuring phones in Cisco Unified Communications Manager, refer to the
following documentation:
• "Cisco Unified IP Phones", Cisco Unified Communications Manager System Guide
• "Cisco Unified IP Phone Configuration", Cisco Unified Communications Manager Administration Guide
• "Autoregistration Configuration", Cisco Unified Communications Manager Administration Guide
The following section provides additional information.
Set Up Cisco Unified IP Phone 6901 and 6911 in Cisco Unified Communications Manager
The following procedure provides an overview of configuration tasks for the Cisco Unified IP Phone 6901
and 6911 in Cisco Unified Communications Manager Administration. The procedure presents a suggested
order to guide you through the phone configuration process. Some tasks are optional, depending on your
system and user needs. For detailed procedures and information, see the sources in the procedure.
Procedure
Step 1
Gather the following information about the phone:
• Phone Model
Cisco Unified IP Phone
24
• Enabled: If you are using a switch that supports multi-domain authentication, you can continue to
use the Voice VLAN.
• Disabled: If the switch does not support multi-domain authentication, disable the Voice VLAN and
consider assigning the port to the native VLAN.
Cisco Unified IP Phone