NETGEAR 7000 Series Managed Switch Administration Guide
Example #2: permit any
(Netgear Switch) (Config-mac access-list)#permit ?
<srcmac>
Enter a MAC address.
any
Configure a match condition for all the destination MAC
addresses in the Destination MAC Address field.
(Netgear Switch) (Config-mac access-list)#permit any ?
<dstmac>
Enter a MAC address.
any
Configure a match condition for all the destination MAC
addresses in the Destination MAC Address field.
(Netgear Switch) (Config-mac access-list)#permit any any ?
assign-queue
Configure the Queue Id assignment attribute.
cos
Configure a match condition based on a CoS value.
<ethertypekey>
Enter one of the following keywords to specify an Ethertype
(appletalk, arp, ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast,
netbios, novell, pppo,rarp).
<0x0600-0xffff)
Enter a four-digit hexadecimal number in the range of 0x0600 to
0xffff to specify a custom Ethertype value.
vlan
Configure a match condition based on a VLAN ID.
<cr>
Press Enter to execute the command.
(Netgear Switch) (Config-mac access-list)#permit any any
7-6
v1.1, May 2006
Access Control Lists (ACLs)