Cli Examples; Example #1: Show Port Security; Example #2: Show Port Security On A Specific Interface; Example #3: (Config) Port Security - NETGEAR ProSafe GSM7328 Administration Manual

CLI Examples

The following are examples of the commands used in the Port Security feature.

Example #1: show port security

(Netgear Switch) #show port-security ?
<cr>
all
<unit/slot/port>
dynamic
static
violation
(Netgear Switch) #show port-security
Port Security Administration Mode: Enabled

Example #2: show port security on a specific interface

(Netgear Switch) #show port-security 1/0/10
Admin
Intf Mode
---- --------
1/0/10 Disabled

Example #3: (Config) port security

(Netgear Switch) (Config) #port-security ?
<cr> Press Enter to execute the command.
(Netgear Switch) (Config) #port-security
Port Security
NETGEAR 7000 Series Managed Switch Administration Guide
Press Enter to execute the command.
Display port-security information for all interfaces.
Enter interface in unit/slot/port format.
Display dynamically locked MAC addresses.
Display statically locked MAC addresses.
Display the source MAC address of the last packet that
was discarded on a locked port.
Dynamic Static
Limit Limit
------- ------
600 20
v1.1, May 2006
Violation
Trap Mode
---------
Disabled
11-3