Advertisement
Hansgrohe has set the electronic thermostat at 38°C (water pressure 3 bar, Dt 50°C). To adjust the electronic
thermostat to the respective local conditions, carefully adhere to the following instructions:
Warning:
Prior to adjustment, check the following points:
- Mains power supply 230V/50Hz (check fuses)
- the water heater must be turned on.
During adjustment the hand shower is automatically turned on.
Should you make an error during programing, press the safety key twice to cancel all previous instructions.
1.
Turn off all showers (overhead, hand shower and body showers).
The hand shower will be automatically turned on during adjustment.
2.
Press safety- and lighting key, and keep depressed until the light flashes.
3.
Using „+" and „-" keys, set display to 1.1C.
4.
Press lighting key.
5.
Semi-automatic motor alignment is activated.
The alignment takes maximum 3 minutes. Within this time the respective temperatures are displayed. When the
alignment is completed the display will again show 1.1C.
Flashing indications 11.1C; 21.1C und 31.1C are error messages which will make it necessary to repeat the
process, from point 4 onwards.
The flashing indications imply incompatible alignment. This could have various reasons:
The cold and hot water supply could be irregular or the water pressure has changed during
9.
Press safety key. (ends programming)
6
Adjusting the electronic thermostat (Motor alignment)
English
alignment.
Advertisement
