Removal Of Cylinder Unit; Removal Of Power Supply Unit - Panasonic DVCPRO50 Service Manual

2. Disconnect 3 connectors (P4001, P5902, P5903).
P5903 P5902
3. Push and rotate the red plastic gear in front of the
Front loading motor counterclockwise until the
screw (B) which is used to fix the Mechanism Unit
can be seen.
4. Unscrew the 3 screws (B).
5. Disconnect the connector (a) which combines
Mecha Unit with MECH IF2.
SCREW (B)
SCREW (B)
(a)
P4001
Rotate the Gear
6. Remove the Mecha Unit lifting the backside of it.

1-6. Removal of Cylinder Unit

(refer to page MECH-40).

1-7. Removal of Power Supply Unit

1. Unscrew the 4 screws (A) and lift-up the Power
Supply Unit.
2. Disconnect a connector (B) and remove the Power
Supply Unit.
Screws (A)
(a)
Notes:
When remove the Power Supply Unit, the
connector (a) which combines the Mother Board
with Power Supply Unit is disconnected.
Check the connector has been connected
securely when the Power Supply Unit is installed.
DIS-3
Connector (B)