RX-DT30
I
n
HOW TO CHECK THE TRAVERSE UNIT
Traverse Unit
3. Set up the traverse unit as shown in diagram.
4. Install the compact disc and disc clamp unit.
:
Note
Before perform checking, make sure the
switch SW401 is switched to "ON" position.
(as shown in diagram).
n
WHAT TO DO WHEN THE TAPE IS ENTANGLED
I
When the tape is caught in the pitch roller, etc. Release the tape
1. Remove the top cabinet unit.
(Refer to disassembly instructions, Fief No. 3)
2. Remove 4 screws.
by turning the pulley on the motor with the screwdriver in the
direction of arrow.
-lO-
( 0 - 0 )