Table of Contents
Advertisement
Juno Tube
User manual
Thank you for purchasing the Lightpro Juno Tube.
This document contains the required information for
correct, efficient and safe use of the product. Consult the
general manual of the Lightpro 12-volt system and the
user manual of your transformer for more information
about the set up and connection of your light plan.
Read the information in this manual carefully before
using the product. Keep this manual near the product for
consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Juno Tube is a standing LED lamp for
outdoor use. The fixture can be mounted on a solid
surface or placed in the ground with the supplied
spikes. This product may only be used as outdoor
lighting in combination with the Lightpro 12-volt
system. Any alterations made to the product may have
consequences for the safety, guarantee and correct
functioning of the product and/or other parts of the
system.
SPECIFICATIONS
Product
Article number
Light source
Power (max)
Luminous flux (max)
Light colour
Average lifetime
Dimensions (h x Ø)
Protection class
Ambient temperature
Cable length
Dimmable
Light source
On/off
PACKAGING CONTENT
[Figure A]
1. Juno Tube luminaire
2. Friction ring
3. Mounting block
3A. Adjusting screw
4. Cover
5. Lightpro connector
6. Allen keys
Juno Tube
213S
LED 4 W AC/DC 12V
4 W
372 lm
3.000K
25.000
85 x 55 x 68 mm
IP65
-20°C to 50°C
3m
No
Not replaceable
10.000
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl
MOUNTING SPOT
[Figure B]
1. Remove the cover cap [4] from the mounting block [3].
2. Use the Allen key [6] to turn the adjusting screw [3A]
in the mounting block [3].
3. Place the friction ring [2] on the mounting block [3].
4. Turn the luminaire [1] with the cables as a package on
the mounting block until you begin to feel resistance
and slide the lamp to the desired position.
5. Slide the mounting block [3] to the desired position.
6. Secure them at the back with the set screw [3A] and
Allen key [6] and place the cover cap [4].
[Figure C]
Route the cable by pushing it into the recess at the back
of the tube.
Carefully slide the mounting blocks over the tube
when the cable is in the tube to avoid damaging the
cable.
Repeat this step in case more luminaires are mounted.
Advertisement
Table of Contents
