Table of Contents
Advertisement
Oberon Lo / Oberon Hi
User manual
Thank you for purchasing the Lightpro Oberon.
This document contains the required information for
correct, efficient and safe use of the product. Consult the
general manual of the Lightpro 12-volt system and the
user manual of your transformer for more information
about the set up and connection of your light plan.
Read the information in this manual carefully before
using the product. Keep this manual near the product for
consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Oberon is a standing LED lamp for outdoor
use. The fixture can be mounted on a solid surface
or placed in the ground with the supplied spikes.
This product may only be used as outdoor lighting in
combination with the Lightpro 12-volt system. Any
alterations made to the product may have consequences
for the safety, guarantee and correct functioning of the
product and/or other parts of the system.
SPECIFICATIONS
Product
Article number
Light source
Power
Luminous flux
Light colour
Average lifetime
Dimensions (H x Ø)
Protection class
Ambient temperature
Cable length
Dimmable
Replaceable light source
PACKAGING CONTENT
[Figure A]
1 Fixture Oberon Lo/Oberon Hi
2 Ground spike
3 Screw
4 Screw
5 Plug
6 Lightpro connector
7 Hex key
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl.
Lightpro Oberon Lo / Hi
190P / 191P
LED 4W AC/DC 12V
4W
40 - 400 lm
3.000K
25.000
420 / 660 x 64 mm
IP44
-20 °C to 50 °C
1m
Yes
N0
INSTALLATION
[Figure B]
Remove the screws [8] from the fixture [1] using the
included hex key [7].
[Figure C]
Haal de voet [9] uit het armatuur [1]Remove the base [9]
from the fixture [1].
OPTION 1: Placement in the ground
[Figure D]
Fasten the spikes [2] to the base [9] with the included
screws [3].
[Figure E]
Place the base [9] in the fixture [1].
[Figure F]
Put the screws [8] back in the fixture using the hex key
[7]. Place the fixture in the ground.
OPTION 2: Placement on a fixed underground
[Figure G]
Mount the base [9] on the underground using the
included screws [4].
If necessary, drill holes in advance and use the
included plugs [5].
[Figure H]
Place the fixture [1] on the base [9].
[Figure I]
Put the screws [8] back in the fixture using the hex key [7].
OPERATION OF THE DIMMER
[Figure J]
Unscrew the head [10] and remove it from the fixture [1].
[Figure K]
Set the desired brightness using the push button on the
underside of the head [10].
The brightness can be adjusted to 6 different levels.
[Figure L]
Put the head [10] back in the fixture [1] and fasten it.
Advertisement
Table of Contents
