Table of Contents
Advertisement
Tiga DL
User manual
Thank you for purchasing the Lightpro Tiga DL.
This document contains the required information for
correct, efficient and safe use of the product. Consult the
general manual of the Lightpro 12-volt system and the
user manual of your transformer for more information
about the set up and connection of your light plan.
Read the information in this manual carefully before
using the product. Keep this manual near the product for
consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Tiga DL is a standing LED lamp for outdoor
use. The fixture can be mounted on a solid surface
or placed in the ground with the supplied spikes.
This product may only be used as outdoor lighting in
combination with the Lightpro 12-volt system. Any
alterations made to the product may have consequences
for the safety, guarantee and correct functioning of the
product and/or other parts of the system.
SPECIFICATIONS
Product
Article number
Light source
Power
Luminous flux
Beam angle
Light colour
Average lifetime
Dimensions (D x W x H)
Protection class
Ambient temperature
Cable length
Dimmable
Replaceable
PACKAGING CONTENT
[Figure A]
1 Fixture Tiga DL
2 Ground spike
3 Screw
4 Plug
5 Fixing clip
6 Hex key
7 Screw for mounting clip
8 Lightpro connector
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl.
8
Tiga DL
209S
LED 5W AC/DC 12V
5W
75 lm
90º
3.000K
25.000
88 x 68 x 63 mm
IP67
-20 °C to 50 °C
1,5m
Yes
N0
INSTALLATION
Option 1: Mounting to the wall.
[Figure B]
1 Remove the screw [7] from the ground spike (2) using
the Allen key (6).
2 Mount the retaining clip (5) to the wall using the screw
(3) (see image B).
Note: The clamping part of the clip should face
upwards.
[Figure C]
3 The Tiga DL (1) can now be installed, as desired, as an
Uplight or Downlight by sliding it over the retaining clip
in the correct way.
Option 2: Positioning in the ground.
[Figure D]
1 Attach the retaining clip (5) to the ground spike (2)
using the screw (7). Use the Allen key (6)
2 Slide the ground spike with the mounted retaining clip
(2) to the Tiga DL (1).
3 Push the fixture into the ground.
DIM FUNCTION
[Figure E]
Press the button to set the desired light output
(6 possibilities).
Dimmable: Yes, in 6 steps with built-in dimmer
Advertisement
Table of Contents
