Table of Contents
Advertisement
GB
Polaris
User manual
Thank you for purchasing the Lightpro Polaris.
This document contains the required information for
correct, efficient, and safe use of the product. Consult
the general manual of the Lightpro 12-volt system
and the user manual of your transformer for more
information about the set up and connection of your
light plan.
Read the information in this manual carefully before
using the product. Keep this manual near the product
for consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Polaris is an LED wall lamp for outdoor
use. The fixture can be fixed to the wall with the
included screws. This product may only be used as
outdoor lighting in combination with the Lightpro
12-volt system. Any alterations made to the product
may have consequences for the safety, guarantee, and
correct functioning of the product and/or other parts
of the system.
Specifications
Product
Article number
Power
Luminous flux
Dimensions (h x Ø)
Protection class
Ambient temperature
Cable length
Dimmable
INSTALLATION
Packaging content
[Figure A]
1. Fixture Polaris
2. Screws
3. Plugs
4. Lightpro connector
Lightpro Polaris
185W
6W
500 lm
35 x 145 mm
IP44
-20°C to 50°C
3m
No
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl
[Figure B]
1. Unscrew the cap from the back plate.
2. Remove the cap from the fixture.
[Figure C]
Optional: Putting the cable through the wall.
1. Drill a hole (Ø10 mm) in the wall for the cable.
2. Open the screw connector in the cable.
3. Put the cable through the hole in the wall.
4. Connect the screw connector in the cable.
[Figure D]
1. Install the back plate with the included screws.
If necessary, drill holes in the wall and use the
included plugs.
2. Place the cap on the back plate.
3. Fix the cap by fastening it into place.
Advertisement
Table of Contents
