Product Description; Installation - LightPro Kuma User Manual

184w 12volt
Hide thumbs Also See for Kuma:
Table of Contents

Advertisement

GB
Kuma
User manual
Thank you for purchasing the Lightpro Kuma.
This document contains the required information for
correct, efficient, and safe use of the product. Consult
the general manual of the Lightpro 12-volt system
and the user manual of your transformer for more
information about the set up and connection of your
light plan.
Read the information in this manual carefully before
using the product. Keep this manual near the product
for consultation in the future.

PRODUCT DESCRIPTION

The Lightpro Kuma is an LED wall lamp for outdoor
use. The fixture can be fixed to the wall with the
included screws. This product may only be used as
outdoor lighting in combination with the Lightpro
12-volt system. Any alterations made to the product
may have consequences for the safety, warranty, and
correct functioning of the product and/or other parts
of the system.
Specifications
Product
Article number
Power
Luminous flux
Dimensions (h x Ø)
Protection class
Ambient temperature
Cable length
Dimmable

INSTALLATION

Packaging content
[Figure A]
1. Fixture Kuma
2. Screws
3. Plugs
4. Lightpro connector
5. Hex key
Lightpro Kuma
184W
6W
300 lm
35 x 145 mm
IP44
-20°C to 50°C
3m
No
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl
[Figure B]
1. Remove the screws from the fixture with the inclu-
ded key (Figure A [5]).
2. Remove the hood from the fixture.
[Figure C]
Optional: Putting the cable through the wall.
1. Drill a hole (Ø10 mm) in the wall for the cable.
2. Open the screw connector in the cable.
3. Put the cable through the hole in the wall.
4. Connect the screw connector in the cable.
[Figure D]
1. Install the back plate with the included screws.
If necessary, drill holes in the wall and use the
included plugs.
[Figure E]
2. Place the hood over the back plate.
3. Place the screws in the fixture.
4. Fix the hood by fastening the screws with the inclu-
ded key (Figure A [5]).

Advertisement

Table of Contents
loading

Table of Contents