Table of Contents
Advertisement
Quartz
User manual
Thank you for purchasing the Lightpro Quartz. This
document contains the information required for the
correct, efficient, and safe use of the product. Please
consult the user manual of your transformer for more
information on how to set up and connect your light
plan, or visit our website: www.lightpro.nl.
Before using the product, please read the information in
this manual carefully. Keep this manual with the product
for future reference.
PRODUCT DESCRIPTION
The Lightpro Quartz is an LED spot for outdoor use. The
fixture can be installed in a fixed underground.
This product may only be used as outdoor lighting in
combination with the Lightpro 12volt system. Any
alterations made to the product may have consequences
for the safety, guarantee, and correct
functioning of the product and/or other parts of the
system.
SPECIFICATIONS
Product
Article number
Light source
Power (max.)
Luminous flux
Beam angle
Light colour
Average lifetime
Dimensions (H x Ø)
Protection class
Ambient temperature
Cable length
Dimmable
Replaceable
PACKAGING CONTENT
1. Fixture Quartz
2. Lightpro connector
3. Ground Spike
4. Screw
5. Plug
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl
8
Lightpro Quartz
196W
MR11 LED G4 2W AC/DC 12V
2W
120 lm
30º
3.000K
25.000
105 x 50 x 85 mm (HxBxD)
IP44
20°C to 50°C
3m
No
Yes
INSTALLATION
Option 1: Ground mounting
[Figure A]
1. Using a suitable Phillips screwdriver, remove the
screw as shown in [1].
2. Remove the part from the casing to which the ground
pin should be attached [2].
3. Now attach the ground pin to the removed part using
a suitable Phillips screwdriver and the two screws in
the ground pin [3] and [4].
4. Place the removed part (see step 1) together with the
ground pin back into the casing [6].
5. Make sure that the cable runs correctly through the
cable entry [5].
Option 2: Wall mounting
[Figure B]
1. Using the supplied screws (2 pcs), mount the removed
part to the wall [7].
2. Carefully place the casing on the wall mount. Make
sure that the cable runs correctly through the cable
entry. For water drainage purposes, the cable should
always come out of the Quartz at the bottom [8].
3. Secure the casing to the wall mount using the
screw [9].
4. By slightly loosening the screw, as shown in [10], the
spotlight can be rotated to the desired position [11]
and [12] for the correct lighting. As the spot is in the
correct position, this screw needs to be tightened
again.
NB
If desired, the cable can be fed through the wall. Drill a
10 mm hole in the desired position through the wall with
a suitable drill.
Feed the small plug with the cable through the drilled
hole. Fit the plug to the appropriate cable with the
appropriate female plug [13].
Option 3: Light source replacement
[Figure C]
1. Using a suitable Phillips screwdriver, remove the two
screws, as shown in [13].
2. Now carefully pull out the lamp holder and remove the
old light source [14].
3. Place a new light source in the holder. Please note;
Only use the specified light source [15].
4. Place the lamp holder back into the casing [16] and [17].
Please note: Put the rubber ring back in the correct
position. There should be no foreign objects between
the rubber ring and the casing.
5. Install the lamp holder in the correct position with the
corresponding screws [13].
Advertisement
Table of Contents
