Installation And Connection; To Install The Software; To Connect The Scanner - Ametek CREAFORM peel 3 User Manual

Installation and Connection

To install the software

The software can be installed on a computer with the
1. Download the software installation file.
2. Double-click the .exe file.
3. Click Next and Install to install all available features.
4. Click Finish to finalize the software installation.
5. Follow instructions and make sure the software license is activated.
The scanner must be connected according to the following procedure to guarantee
its physical integrity and to avoid any damage.

To connect the scanner

VOLTAGE:
Handle the scanner's power cord with care.
Do not disconnect the scanner by pulling on the wire, and do not carry the scanner
by the cord.
Keep the cord away from materials or tools that could damage it (e.g., chemical
products, cutting tools, heat, etc.).
Do not allow the electrical wire to be pinched or twisted.
Always disconnect the scanner before storing or when it is not in use or under
supervision.
Please follow the safety maintenance recommendations from the manufacturer.
DANGER:
Electric shock hazard
Do not use the products near water, in a moist environment or in rain, snow, etc.
Do not immerse the products.
Any alterations or modifications of the products may pose a danger to the user and
are therefore prohibited.
The power cord is equipped with a polarized, 2-prong plug. For safety, it fits into
the power outlet one way. Never circumvent this safety feature.
peel 3 User Manual version p3d-2209-001 (last update: 2022-09-13)
specifications required by Creaform.
Page 14 of 23