Advertisement
5, Select the corresponding serial number which need to start, then you
can realize the switching function.
Under the "Hyper terminal" operating system:
1, Start the "hyper terminal" software. (Menu Procedure Communication
hyper terminal, then press Enter)
2,
Input the name as your preference New Connection show interface, +
Enter.
3, Select the correct serial port number, + Enter.
4, BPS set to 9600, DFC select "no". + Enter
5, Input the "Input port No" of the switcher as the serial No of DOS system,
such as
1
Enter.
6, Select the corresponding serial number which need to start, then you
can realize the switching function. (Hyper terminal is the software comes with
the computer system, if no, you can download it through the internet.)
5.3 Connection Diagram
2
3
4
SDI 8X1 Switcher with Reclock
5
6
3
7
8
+
Advertisement
