Enabling Remote Management Access - NETGEAR ProSafe FVS338 Reference Manual

Note: The password and time-out value you enter will be changed back to password
and 5 minutes, respectively, after a factory defaults reset.

Enabling Remote Management Access

Using the Remote Management page, you can allow an administrator on the Internet to configure,
upgrade, and check the status of your VPN firewall. You must be logged in locally to enable
remote management (see
Note: Be sure to change the firewall default configuration password to a very secure
password. The ideal password should contain no dictionary words from any
language, and should be a mixture of letters (both upper and lower case), numbers,
and symbols. Your password can be up to 30 characters. See
and Settings" on page 6-7
Figure 6-2
To configure your firewall for Remote Management:
1. Select the Turn Remote Management On check box.
Router and Network Management
FVS338 ProSafe VPN Firewall 50 Reference Manual
"Logging in to the VPN Firewall" on page
for the procedure on how to do this.
v1.0, September 2006
2-1).
"Changing Passwords
6-9