How To Use The Vpn Wizard To Configure A Vpn Tunnel - NETGEAR FVS328 Reference Manual

How to Use the VPN Wizard to Configure a VPN Tunnel

Note: If you have turned NAT off, before configuring VPN IPSec tunnels you must first
open UDP port 500 for inbound traffic as explained in
VPN Tunnels when NAT is Off" on page
Follow this procedure to configure a VPN tunnel using the VPN Wizard.
Note: The LAN IP address ranges of each VPN endpoint must be different. The connection will
fail if both are using the NETGEAR default address range of 192.168.0.x.
Log in to the FVS318 on LAN A at its default LAN address of
1.
default user name of
main menu to display this screen. Click Next to proceed.
Figure 7-5: VPN Wizard Start Screen
Fill in the Connection Name, pre-shared key, and select the type of target end point, and click
2.
Next to proceed.
Virtual Private Networking
Model FVS328 ProSafe VPN Firewall with Dial Back-up Reference Manual
and password of
admin
May 2004, 202-10031-01
"Example: Port Forwarding for
6-10.
http://192.168.0.1
. Click the VPN Wizard link in the
password
with its
7-15