NETGEAR FVS328 Reference Manual page 185

Figure F-8: NETGEAR FVS328 VPN – Auto Policy (part 1)
– Enter a unique name to identify this policy. This name is not supplied to the remote VPN
endpoint. In our example we have used "to318" as the Policy Name. In the Policy Name
field type to318.
– From the IKE policy drop-down box, select the IKE Policy that was set up in the earlier
step – this being the FVS318 IKE Policy.
– From the Remote VPN Endpoint Address Type drop-down box, select IP Address.
– Type the WAN IP Address of Gateway A (14.15.16.17 in our example) in the Remote
VPN Endpoint Address Data field.
– Type 300 in the SA Life Time (Seconds) field.
– Type 0 in the SA Life Time (Kbytes) field.
– Check the IPSec PFS check box.
– From the PFS Key Group drop-down box, select Group 2 (1024 Bit).
– From the Traffic Selector Local IP drop-down box, select Subnet address.
– Type the starting LAN IP Address of Gateway B (172.23.9.1 in our example) in the Local
IP Start IP Address field.
– Type the finishing LAN IP Address of Gateway B (0.0.0.0 in our example) in the Local IP
Finish IP Address field.
NETGEAR VPN Configuration FVS318 or FVM318 to FVS328
Model FVS328 ProSafe VPN Firewall with Dial Back-up Reference Manual
May 2004, 202-10031-01
F-7