Table of Contents
Advertisement
Closed-loop communication with a Power Conversion device requires using the
LYNK II Communication Gateway device from Discover Battery. Refer to the relevant
LYNK II Installation and Operation Manual available from the
www.discoverbattery.com website, or contact your Discover Battery provider for
assistance.
Refer to the appropriate Application Note available from www.discoverbattery.com
for the set up of closed-loop parameters and integration with specific brands of
solar inverter-chargers, solar charger controllers, mobile inverter-chargers, and
industrial chargers.
7.3 AEbus (LYNK) Network Communication
Discover batteries use CAN communication over the AEbus (LYNK) Network to
coordinate performance with other batteries and communicate with accessories
such as the LYNK Communication Gateway.
• Terminating resistors are required when deploying the battery in an AEbus (LYNK)
Network.
7.3.1 AEbus (LYNK) Network Power
The Discover battery provides the AEbus (LYNK) Network power through the AEbus
(LYNK) Port.
• Do not use an external power source to power devices over the AEbus (LYNK)
Network.
7.3.2 7.3.2 AEbus (LYNK) Network Size
One AEbus (LYNK) Network can support up to 13 AES LiFePO
7.3.3 AEbus (LYNK) Network Cable
Use CAT5 cables for batteries on the AEbus (LYNK) Network.
8. OPTIONAL ACCESSORIES
The following optional accessories are available for the AES LiFePO
Accessory
LYNK II Communication Gateway
AES LiFePO
Wall-Mount Bracket
4
NOTICE
NOTICE
Part Number
950-0025
950-0018
13
batteries.
4
battery.
4
Advertisement
Table of Contents
