Table of Contents
Advertisement
6.1 Internal Battery Fuse
The internal battery fuse provides backup overcurrent protection.
Additional external DC fusing is required to protect the battery cables from DC
overcurrent and to meet installation codes.
6.2 ON/OFF Key
Press the battery's ON/OFF key for 2 to 3 seconds to switch the battery either ON or
OFF . The LED illuminates when the battery is ON and darkens when the battery is
OFF .
ELECTRIC SHOCK HAZARD
• Always assume the battery's main relay is ON (Closed), even if the LED for the ON/
OFF key is not illuminated.
• Verify the terminal voltage with a voltmeter before handling and installing the battery.
Failure to follow these instructions may result in death or serious injury.
ON/OFF LED
Dark
Illuminated
Flashing at 1 Hz
interval
6.3 AEbus Port (LYNK Port)
The AEbus Port (LYNK port) enables multiple Discover batteries to communicate
and interact in a closed-loop network. The AEbus Port also enables AES LiFePO
batteries to be networked in a closed-loop system with other networked devices
such as external power conversion and motor control devices. A closed-loop system
enhances safety and optimizes system performance.
WARNING
Description
The battery's main relay is OFF (Open).
The main relay is ON (Closed), and the battery is ready for
operation.
The main relay is OFF (Open). The flashing indicates protection
has been triggered as one or more operating parameters (voltage,
current, temperature) have exceeded their fault threshold.
Refer to Table 3-4, Protection Specifications, for information on
faults that trigger protection.
NOTE
2-3s
10
4
Advertisement
Table of Contents
