Confirming Voltages - Ocean Sonics Processing Buoy User Manual

Appendix A

Confirming Voltages

A voltmeter can be used to confirm the proper voltage is being supplied to the array on the
buoy.
1. Place the negative voltmeter lead (black) into pin 1 of the MCBH8F bulkhead.
connector on the battery pack end cap for the common connection (pinout below).
2. Place the positive voltmeter lead (red) into pin 7 (pinout below).
Fully Charged Batteries should measure approximately ~25 V.
Batteries should not be discharged past 21 V.
MCBH8F Bulkhead Connector Pinout
Ocean Sonics Processing Buoy User Guide April 2020 P.10