Service Optical Device, Wire (Flat Type) - Sony HCD-GPX33 Service Manual

HCD-GPX33/GPX55/GPX77/GPX88
2-8.

SERVICE OPTICAL DEVICE, WIRE (FLAT TYPE)

Note 1 : Before disconnecting the fl exible fl at cable (24 core) of optical pick-up block, solder the short-land.
1 six claws
8 four insulator screws
qs service,
optical device
qa insulator
6 belt
3 Insert the thin
wire (clip etc.).
4
Note: This illustration sees the loading assy (T) from bottom side.
1 flexible flat cable (24 core)
loading assy (T)
terminal face
2 Through the hole
12
2 chuck holder assy (T)
qa insulator
0
9
qd base, lo assy
7 connector
5 tray
5 two claws
3 Through the hole
Under the guide
(Fold area)
Under the guide
2 Solder the short-land.
Note 2: When assembling the optical pick-up block,
remove the solder of short-land after
connecting the flexible flat cable (24 core).
qa insulator
qg
– Bottom view –
5 three claws
6 holder, FFC
4
7 wire (flat type) (24 core)
qf wire (flat type)
(5 core)
qh holder, FFC
qj flexible flat cable
(24 core)
loading assy (T)
8 wire (flat type)
(5 core)