Honeywell Home T3 Manual page 7

Install Thermostat(T3 and T3M only)
A. Wall plate
Mount the back‐plate to the wall.
Connect wires according to wiring
diagrams.
Power Up the Thermostat (T3 and T3R only)
Insert the batteries
Setup and Configuration
After power up, the year selection is displayed on the thermostat's screen.
Press + or – to adjust the date and time and press to confirm
BINDING(T3R only)
The T3R thermostat wireless kit comes pre‐bound from the factory.
The binding operation described below is only required if:
• The T3 thermostat or the Receiver box is replaced
• The T3 thermostat or the Receiver box has incorrect or no binding data stored
To bind/rebind
Note: When the Receiver box has been bound before, first press with a small pin
the pinhole for approximately 3 seconds to reset the binding, LEDs will flash
amber for a moment.
1. Put the Receiver box into binding mode by pressing the button for 3 secs.
The LED will flash amber.
2. Enable binding on thermostat:
Enter binding menu by pressing and hold the for 3 secs and the press
the – button.
Change parameter 14A to 1 and press to confirm
3. When binding is successful:
The will appear on the thermostat's screen.
The Receiver box status LED will show steady green
T3 PROGRAMMABLE THERMOSTAT
B. Surface wiring
Attach the front cover to the
back plate.
C. Place thermostat
Fit the flap on to the thermostat
Status
LED
Demand
Button
Reset