Input Settings - Kenwood DMX7022S Instruction Manual

Settings Settings

Input settings

1 Display the <Input> screen.
On the source/option selection screen (page 11):
Then, on the <SET-UP> screen, touch as follows:
[Input] (1) → [Enter] for the item you adjust or
the appropriate setting for the item (2).
SET-UP
Rear Camera
Audio Enter
AV Input
Display AV-IN
Input
System
2
Adjust the item if more steps are required.
See the respective explanation that follows.
<Rear Camera>
Configure the rear view camera settings.
<Rear Camera Interruption>
• ON (Initial): Displays the picture from the rear view
camera when you shift the gear to the reverse (R)
position.
– A caution message appears on the screen. To
remove the caution message, touch the screen.
• OFF: Select this when no rear view camera is
connected.
<Parking Guidelines>*
• ON (Initial): Displays the parking guidelines.
• OFF: Hides the parking guidelines.
Camera
<Guidelines Setup>*
Adjust the parking guidelines according to the size of
the car, parking space and so on.
When adjusting the parking guidelines, make sure to
use the parking brake to prevent the car from moving.
Select the
the selected
Initialise
mark (1), and then adjust the position of
mark (2).
Make sure that A and B are horizontally parallel, and
that C and D are the same length.
• Touch and hold [Initialise ] for 2 seconds to set all
the marks to the initial default position.
<Reverse with ATT>*
• ON (Initial): The sound is attenuated while the gear is
shifted to the reverse (R) position.
• OFF: Not used.
* When an around view monitor (AVM) is connected, these settings
become invalid.
<AV Input>
Select the usage of the AV-IN input terminal
(adjustable only in Standby Mode (page 4)).
• AV-IN (Initial): Select this when an external AV device
is connected.
To watch the connected device, select [AV-IN] on
the source/option selection screen.
• Camera: Select this to watch the view from the
connected camera.
To watch the camera view, select [Camera] on the
source/option selection screen.
ENGLISH 37