Table of Contents
Advertisement
Settings
Settings
2
Display the <X'over Network> screen.
Press the VOL
K
button on the monitor panel and
touch the upper right portion on the touch panel
at the same time:
3
Select the crossover network mode.
[2 way]
Select this when 2-way system
speakers are used (front/rear).
[3 way]
Select this when 3-way system
speakers are used (tweeter/mid
range/subwoofer).
A confirmation message appears. Touch [Yes].
Now, you can adjust the <Speaker/X'over>
settings.
1
Display the <SET-UP>
<Audio>
→
<Speaker/X'over> screens (page
32
ENGLISH
2
Select a car type (
of the speakers (
<Speaker Select> screen (
Car Setting
OFF
Front
* <Speaker Location> is available only when <X'over
Network> is set to [2 way].
<Speaker Location> for speakers is only available when the
speakers are selected for <Speaker Select>.
3
Select the speaker type (
size of the selected speaker (
display the <X'over> screen (
Speaker Select
→
30).
1
), select the location
2
)*, and then display the
3
).
OFF
Lower Door Area
1
), select the
2
), and then
3
).
16 cm
• If a speaker is not connected, select [None].
• When setting the front speakers, select the
speaker size for <Tweeter>.
4
Adjust the crossover frequency of the
selected speaker.
• Adjustable items vary depending on the selected
speaker type/speaker size/crossover settings.
X'over
Front
[dB]
TW Gain
0dB
Gain
0dB
HPF FREQ
30Hz
Slope
-24dB/Oct
Eg. when adjusting <X'over> for front speakers
<Gain>/<TW Gain>
Adjusts the output volume of respective speaker.
<HPF FREQ>/<LPF FREQ>
Adjusts the crossover frequency for respective
speaker.
<Slope>
Adjusts the crossover slope for respective speaker.
<Phase>
Selects the phase for the speaker.
[Hz]
Advertisement
Table of Contents
