Enter Setup - Navman X300 Quick Start Manual

Step 2
Get set
Know the buttons
The control buttons,
separately or together to turn the unit «ON» and «OFF», cycle
through modes, and select mode options.
Know the startup options

1. enter setup

2. start normal operation
!
Always enter setup first if you wish to change settings.
To enter setup after starting normal operation, you must
shut down and re-start the X300.
Flashing icon = seeking GPS signals
Constant icon = GPS signals obtained
Startup could take up to 80 seconds to get all satellite data.
Enter setup
Press and hold
If you release before the counter reaches zero, the X300
will immediately start normal operation.
For details about system settings see over page or consult User Guide.
Press and hold
After leaving setup, the X300 automatically starts normal
operation displaying the speed mode first.
and (as shown above) are pressed
to enter setup
counter
to leave setup
counter
X300