Set (31-12) lets you set dd-mm or mm-dd date format Calc up When ‘calc up’ is «ON» the X300 calculates data for all movement (uphill and downhill). When ‘calc up’ is «OFF» the X300 calculates information for downhill movement only.
Page 3
(31-12) edit Calc up edit beep edit set units (km/h) edit set offset X300 X300 — Settings editing details set 12hr set (12hr) set 24hr set 31-12 set (31-12) set 12-31 Calc up ON Calc up Calc up OFF...
Timer Recall lets you recall stored lap data. Repeatedly pressing lap data starting from the last stored lap, then lap 1, 2, 3 etc. Press and hold to shut down the X300 X300 X300 — Modes «OFF» recalls...
Page 5
1 = press this button = press this button = press both buttons together = press and hold both buttons together X300 — Modes Zone ON edit Zone MIN Zone MAX...
D-ring clockwise to seal. Fit the X300 The X300 is designed to be worn on the left upper arm. You may wish to adjust some of the settings prior to fitting. Be outdoors...
For details about system settings see over page or consult User Guide. Press and hold to leave setup After leaving setup, the X300 automatically starts normal operation displaying the speed mode first. X300 (as shown above) are pressed...
Start normal operation Press to start normal operation When starting directly into normal operation X300 will start in the mode it was in at last shutdown. The X300 automatically operates whenever you are moving and pauses operation while you are stationary. Modes are...