Industry Canada - Bosch GDS18V-330C Operating/Safety Instructions Manual

1605A00164 GDS18V-330C 20220224.qxp_GDS18V-770 2/25/22 1:25 PM Page 15
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
"Exposure to Radio Frequency (RF) Signals:
The wireless device is a radio transmitter
and receiver.
manufactured not to exceed the emission
limit for exposure to radio frequency (RF)
energy set by the Ministry of Health
(Canada), Safety Code 6. These limits are
part of comprehensive guidelines and
established permitted levels of RF energy
for the general population.
These guidelines are based on the safety
standards previously set by international
standard bodies. These standards include a
substantial safety margin designed to
assure the safety of all persons, regardless
of age and health.
This device and its antenna must not be co-
located or operating in conjunction with
any other antenna or transmitter.

Industry Canada

This device complies with Industry Canada
licence-exempt RSS standard(s). Operation
is subject to the following two conditions:
(1) this device may not cause interference,
and
(2) this device
interference, including interference that
may cause undesired operation of the
device.
Connectivity
It is designed and
must accept any
Using "Bosch Toolbox" app
After pairing your tool with a mobile device
you can adjust certain functions or check
the status of the power tool using Bosch
Toolbox app (Fig. 8 and Fig. 9).
Every time you change any setting, the tool
will confirm the changes by flashing the
Status indicator LED (12) blue.
A. Help button – Tapping this button will
bring up help screen.
B. Tool photo – Tapping the photo will let
you customize the photograph of the
tool.
C. Power tool battery charge status – The
number of battery icons in green
indicates the estimated charge level of
the battery pack. Note: Number of
battery icons may not be equal to the
number of LEDs on the battery fuel
gauge.
D. Power tool nickname – Tapping the
"pencil" icon will let you customize the
tool nickname. You can also do it when
changing the tool photo.
E. Connection
connection
indicated by vertical bars. You can use
the toggle switch to disconnect the tool
from your mobile device.
F. Assigned modes – Allows you to define
two modes of operation (A and B),
specifying options such as Auto Shut
Off, Auto Slow Down, and the direction
of rotation for each mode.
G. RPM Adjustment – Allows you to select
the rotation speed.
H. Soft Start – Allows speed ramp-up of
the tool.
I. Work Light – Allows you to set the
work light's brightness and afterglow.
J. User Interface – Allows you to set the
brightness and afterglow of the user
interface.
15
status bar – The
(signal) strength is