Names And Functions Of Main Parts - Toshiba TOSVERT VF Series Instruction Manual

2. Names and functions of main parts

The drawings below show names and functions of main parts.

Front view
RUN lamp
Lights when an ON
command is issued but no
frequency signal is sent
out. It blinks when
operation is started.
"COPY MODE" lamp
Lights when the Remote
Keypad is in "COPY MODE"
*3
Potentiometer lamp
Lights when the
potentiometer is enabled.
*3
Potentiometer
Operation frequency can
be changed when the
built-in potentiometer
lamp is lit
RUN key lamp
Lights when RUN key
is enabled.

Reverse view
Seal material
Seal material for
installation.
Communication
connector
Connect
communication cable
Screw hole
For mounting
screws
*1: These lamps are not lit when Remote Keypad is connected to VF-S11, VF-nC1, VF-S9, VF-A7, VF-P7 etc.
*2: The lamp is not lit when Remote Keypad is connected to an inverter without [EASY] key.
PRG lamp
Lights when the inverter is Lights when the inverter
in parameter setting mode.
8 ( ( 8
RUN PRG
COPY
MODE
EASY
RUN
STOP
A
In "REMOTE KEYPAD MODE", the key functions are the same as that of
the inverter. See the inverter instruction manual.
In "COPY MODE", refer to the next page about the key functions.
MON lamp EASY lamp
Lights when the inverter
is in monitor mode.
is in EASY mode.
MON
MODE
SFT
ESC
ENT
C
B
Operation keys
7
*2
Display
Displays setting,
device status, trip
information, etc.
% lamp
%
Lights when displayed
Hz values are %.
EASY
Hz lamp
Lights when displayed
values are Hz.
Up/Down key lamp
Frequency setting by
up/down keys are
enabled while this lamp is
Screw hole
For mounting
screws
Communication
Mode Switch
Select communication
mode
RS485:
VF-AS1, etc.
LOGIC:
VF-S11,VF-nC1,
VF-A7, etc.
E6581277
*1
*1
lit.