Testing; Cleaning And Repair - Access MONTANA Installation Manual

TESTING

Power up the bath and test the unit is functioning
by operating the 'Seat up' and 'Seat down' buttons
so that the seat moves ensuring the green power
indicator light is visible on the control box�
12 M O N TA N A I N S TA L L AT I O N M A N U A L
Seat up
Seat down

CLEANING AND REPAIR

The installation is now complete� Ensure the bath
is free from debris� Clean the door and seal with
clean soapy water, removing any grit or build-up
of dirt� Fill bath with water and check for leaks�
For everyday cleaning guidelines please refer
to the user guide�
Should the coloured finished surface of the bath
become marked or scratched, it is normally
possible to rectify quite simply� Firstly, apply
1000/1200 grade wet and dry paper, initially using
it dry� After the mark has been reduced, use with
soapy water�
To restore the finish to the bath, apply a cutting
paste such as 'T' Cut or Brasso, and finally finish
off with a silicone-based polish such as car wax
or 'Mr� Sheen'�
When not in use the door should be
left in the closed position, although
not in the fully latched closed position.
This will prevent the hinges being
strained whilst stopping the seal
becoming compressed over time.