Table of Contents
Advertisement
ELECTRICAL WORK
All electrical work must comply
current regulations and should only
be carried out by a qualified electrician.
1 The electrical supply should be fed via the
mains through an RCD to 5 Amp IP65 rated
Non-Switched Fused Spur where the power
cable (supplied with the bath) is hard-wired
connected� The control box and battery
are located on the end frame of the bath, see
FIG. 10� A pre-wired lead is supplied and this
should be run to the mains supply�
2 The mains lead should be left long enough so
that the control box can be removed if servicing
is required�
We advise the electrical non-switched
NOTE
fuse spur is accessible so the property owner
can isolate the unit if required (i.e. not behind
panels or boxed in).
ACCESSORIES / OPTIONS
Where options are fitted (i.e. spa, lights etc.)
a 13 Amp IP65 rated non-switched fused spur
is also required�
FIG. 10
10 M O N TA N A I N S TA L L AT I O N M A N U A L
The second spur is required to ensure the bath
will continue to operate should there be a fault
in the accessory fitted.
HANDSET
See info on PAGE 11�
EARTH BONDING
Earth bonding and cross bonding is mandatory
for this appliance� This should carried out by a
qualified electrician. Earth Bonding and Cross
Bonding are to be fitted and tested for continuity
in accordance with IEE regulations. Trailing flex
should be protected by conduit when IP box is
situated outside of the bath panels�
BATTERY BACK-UP
In the event of a power-cut the seat is protected
by Battery Back-up�
As the battery back-up begins to lose power, an
audible beep will be heard each time the 'seat
down' button is pressed�
SEAT
In battery back-up mode the seat will still operate
but at half speed� In this event we strongly
recommend that you raise the seat and exit the
bath at your earliest convenience�
Advertisement
Table of Contents
