Table of Contents
Advertisement
POST Memory Test
Normally, the only visible POST routine is the memory test. The screen that appears when the system is powered on is shown below.
A BIOS Identification string is displayed at the left bottom corner of the screen, below the copyright message. Press <Ins> during system boot to display two
additional BIOS ID strings. These strings contain the options installed in the AMIBIOS.
If a problem occurs with the system, copy the BIOS ID strings on a sheet of paper before consulting Technical Support. Set Wait for <F1> If any Error in
ADVANCED CMOS SETUP to Enabled.
When a problem occurs, freeze the screen by powering on the system and holding a key down on the keyboard to cause a Keyboard Error message. The
following is displayed after POST is completed:
Hit <DEL> if you want to run SETUP
Press <Del> to access AMIBIOS Setup.
Advertisement
Table of Contents
