Table of Contents
Advertisement
Garage Door Opener
1
1
While the car is ON, hold the handheld garage door transmitter
1-3 inches from the HomeLink® button you want to program in
the vehicle.
2 2
Push and hold both the HomeLink® button being programmed
and the button on the garage door transmitter.
TO ERASE ALL SET CHANNELS:
Push and hold the two outside HomeLink® buttons for 20 seconds until
the orange indicator flashes. An individual channel cannot be erased.
?
?
ROLLING OR NON-ROLLING?
Check your garage door opener motor in your
garage for a "LEARN" or "TRAIN" button by the
hanging antenna. If you have one of these, you
have a Rolling Code garage door opener.
For Non-Rolling Code garage door openers, watch for
3
3
the indicator light to go constant.
For Rolling Code garage door openers, watch for the
indicator light to go from a slow blink to blinking rapidly.
4
4
For Rolling Code garage door openers only, firmly push
and release the "LEARN" or "TRAIN" button on your
garage door opener motor in your garage, then push the
HomeLink® button in your vehicle for two long presses.
5
5
If the programming was successful, your
garage door should open and close with
your chosen HomeLink® button.
NEED ASSISTANCE?
1-800-355-3515
Scan For
HomeLink®
Video
Advertisement
Table of Contents
