Agri-Fab 45-0382 Owner's Manual page 6

12. Insert the end of the flow control rod through the slot in
the flow control mounting bracket and through the hole
in the flow control lever. Secure with a 1/8 in. x 3/4 in.
cotter pin. See figure 8.
FLOW
CONTROL
LEVER
FIGURE 8
13. Install the adjustable stop on the slot in the top of
the flow control mounting bracket. Secure with the
1/4 in. x 3/4 in. carriage bolt, a nylon washer, a 1/4 in.
flat washer and the nylon wing nut. See figure 9.
1/4-20 WING NUT (M)
FIGURE 9
1/8 x 3/4 in.
COTTER PIN (K)
FLOW
CONTROL
ROD
45_0382Fig8
1/4 in. WASHER (F)
ADJUSTABLE
STOP (O)
1/4-20 x 3/4 in.
CARRIAGE BOLT (D)
45_0382Fig9 45_0382Fig9
14. Adjust the position of the flow control mounting bracket
(figures 10 and 11):
a. Set the adjustable stop at "5." Latch the flow control
lever against the stop. Verify that the closure plate
has opened about halfway. See figure 10.
b. If closure plate is not open halfway, adjust the position
of the flow control mounting bracket until the closure
plate is open about halfway at "5" and still closed when
the lever is in the "OFF" position. Carefully tighten
the 1/4 in. nylock nuts. Do not deform the slots in the
flow control mounting bracket.
c. Push the flow control lever to the "OFF" position
and ensure the closure plate closes completely.
See figure 11.
1/4 in. NYLOCK NUTS
FIGURE 10
FIGURE 11
6
POSITION 5
ADJUSTABLE
STOP
45_0382Fig11
ADJUSTABLE
STOP
OFF
45_0382Fig10 45_0382Fig10