Agri-Fab 45-0382 Owner's Manual page 5

7. For the standard setup, use the holes shown in
the illustration. Other hole combinations allow
different handle heights and hopper angles. Do
not use holes in stand that are farthest apart as a
combination - flow gate may not close completely.
Attach the stand to the hopper frame tube using two
1/4 x 1-1/ in. bolts and nylock nuts. Attach the stand
to the lower handle using two 1/4 x 1-1/ in. bolts and
nylock nuts. Tighten all four bolts to secure the stand.
See figure 4.
USE THIS
HOLE
FIGURE 4
8. Attach the two upper handles together with
the flow control bracket as shown using three
1/4 x -1/ in. bolts and nylock nuts. Do not tighten
two bolts in flow control bracket. Tighten third bolt in
upper handles. See figure 5.
1/4-20 NYLOCK
NUT (E)
FIGURE 5
1/4-20 NYLOCK
USE
NUT (E)
MIDDLE
HOLE
1/4-20 x 1-1/2 in.
HEX BOLT (B)
45_0382Fig4
1/4-20 x 2-1/2 in.
HEX BOLT (A)
1/4 in. WASHER (F)
45_0382Fig5
9. Install a handle grip on each handle. See figure 6.
10. Attach the flow control lever to the bracket using one
1/4 x 3/4 in. bolt, nylon washer and nylock nut. Tighten
carefully to allow the lever to move freely. Install the
vinyl grip. See figure 6.
HANDLE
GRIP (P)
1/4 in. NYLON
WASHER (G)
1/4-20 NYLOCK
NUT (E)
FIGURE 6
11. Attach the spring to the stainless steel pattern plate as
shown. Attach the opposite end of the spring to the 1/8
in. hole in the flow control rod. Rotate the end of the rod
into the flow control link. See figure 7.
SPRING (L)
1/8 in. HOLE
FIGURE 7
5
1/4-20 x 3/4 in.
HEX BOLT (C)
LEVER
GRIP (Q)
LEVER
SPRING
ANCHOR
HOLE
FLOW
CONTROL
LINK
45_0382Fig6
45_0382Fig7