Advertisement
%
If the engine oils listed in the table are not
available, you may add a maximum of 1.0 litre
of the following engine oils once only.
Engine oils for one-time lling only in exceptional
cases:
MB-Freigabe or MB-Approval 229.51 or
R
ACEA C3
The following values refer to an oil change, includ-
ing the oil lter.
Model
Model
G 500
G 350 d, G 400 d
N N o o t t es on br
es on brak ake e uid
uid
Observe the notes on operating uids
(
page 408).
/
& W W ARNING
ARNING Risk of an accident due to
vapour pockets forming in the brake sys-
tem
The brake uid constantly absorbs moisture
from the air. This lowers the boiling point of
the brake uid. If the boiling point is too low,
vapour pockets may form in the brake system
when the brakes are applied hard.
This impairs the braking e ect.
Have the brake uid renewed at the
#
Capacity
Capacity
speci ed intervals.
9.5 litres
Have the brake uid regularly replaced at a quali-
ed specialist workshop.
9.0 litres
Only use a brake uid approved by Mercedes-
Benz according to MB-Freigabe or MB-Approval
331.0.
Coolant
Coolant
N N o o t t es on coolant
es on coolant
Observe the notes on operating uids
(
page 408).
/
Technical data 415
& W W ARNING
ARNING Risk of re‑ and injury from
antifreeze
If antifreeze comes into contact with hot com-
ponent parts in the engine compartment, it
may ignite.
Allow the engine to cool down before
#
you top up the antifreeze.
Make sure that no antifreeze spills out
#
next to the ller opening.
Thoroughly clean the antifreeze from
#
component parts before starting the
vehicle.
* N N O O TE TE Damage caused by incorrect cool-
ant
Only use coolant that has been premixed
#
with the required antifreeze protection.
Information on coolant is available at the fol-
lowing locations:
In the Mercedes-Benz Speci cation for
R
Operating Fluids 320.1
415
Advertisement
