From Vehicle Battery; From Bottled Gas; Mounting The Wheels - Dometic PowerFridge RC3000 Operating Instructions Manual

Hide thumbs Also See for PowerFridge RC3000:
Table of Contents

Advertisement

5.2. Operating from vehicle battery
Make sure the voltage shown on the data plate of the
appliance matches the voltage of the vehicle battery
(12V or 24V).
12V DC voltage appliances are equipped with
connectors that can be plugged into cigarette lighters
(Figure 3.). For some types of vehicle, you may need
to remove the red plastic ring located on the end of
the connector. To do so, turn the plastic ring in an anti-
clockwise direction and pull it off. The appliance can
then be connected to the cigarette lighter. In 12V
operation, the appliance runs uninterrupted without
temperature control.
24V DC voltage appliances are shipped with bare wire
ends. The wire ends must be connected to a terminal
block, which is in turn connected to the vehicle
battery via a 5A fuse and 5A switch.
For 12V or 24V operation, make sure, if the
engine is not running, that the appliance
connector is removed from the cigarette lighter (12V
appliance) or that the switch is turned off (24V
appliance). Otherwise, the appliance will discharge
the vehicle battery when in operation.
5.3.
Operating from bottled gas
Connection to the gas cylinder is described in
sections 11.3. and 11.4.
After opening the valve of the gas cylinder, push the
safety gas valve down (Figure 4) and set it to the large
flame symbol, holding it down for about 10 seconds.
Next, press the piezo-igniting button (marked with a
star) several times one after the other. If the flame does
not ignite, repeat the process. (Air in the appliance gas
line prior to connection to the gas cylinder must be
evacuated. Only then can the gas be lit.)
Ignition of the flame can be verified through the flame-
view opening (Figure 5). After you have got the flame
keep the safety gas valve down another 20 seconds.

6. Mounting the wheels

The wheel set, found inside the appliance, consists of
the following parts:
2 wheels
1 axle
1 axle-retaining screw
1 pull handle
1 handle fastener
2 screws for the pull handle
6
Figure 3.
Figure 4.
Figure 5.

Advertisement

Table of Contents
loading

Table of Contents