Rs-232 Specifications - Navitar 10K User Manual

RS-232 Specifications

Configuration of the Terminal
The Commands
Connection to the Control Signal Terminal
To control the SUPERNOVA 10K by serial protocol, connect a 1:1 RS-232 cable to
the projector and adjust the configuration of the terminal to:
Baud 9600 8N2 Xon/Xoff
8 databits
no parity
2 Stopbits
bxx Random access x = slide 1-80
j00 Slide forward
j01 Slide backward
j05 Shutter open
j06 Shutter close
j07 Focus 1 step forward
j09 Focus 1 step backward
j11 Reset projector
j12 Slide position
j22 Projector version
j23 Software version
j24 Autoshow switch on
j25 Timer switch on
j26 Autoshow / Timer switch off
j27 Auto focus switch on
j28 Auto focus switch off
Pin 2 = Receive data (RXD)
Pin 3 = Transmit data (TXD)
Pin 5 = Signal ground (GND)
Pin 9 = Remote start (connect permanently with pin 5)
18