Table of Contents
Advertisement
ATTACH GRAB RAIL
NOTE: It is recommended to use more than one person for
this step to ensure the lift stays upright at all times.
1.
Align the two (2) ends of the Grab Rail so they are in
line with the cylindrical ends of the Cradles and
insert fully as shown in Figure 3.
2.
Attach one (1) 1/2" Washer to one (1) 1/2" x 2-1/2" Hex
Bolt and insert it into the Grab Rail mounts. Slip a
1/2" Lock Washer, 1/2" Washer and 1/2" Hex Nut onto
the protruding end of the bolt and hand tighten.
Repeat for remaining end of the Grab Rail.
Figure 3
REQUIRED PARTS
Grab Rail
QTY: ( 1 )
9
HARDWARE
QTY:
1/4" x 2-1/2" Hex
2
Bolt
1/4" Lock nut
2
1/4" Washer
4
Advertisement
Table of Contents
