Golden LAUNCH STANDARD Instruction Manual page 8

ATTACH CRADLES
NOTE: It is recommended to use more than one person for
this step to ensure the lift stays upright at all times.
1. With the ladder assembly standing straight up, slide
the Cradle into the cradle support located at the
bottom of the ladder assembly as shown in Figure 2
ensuring the holes are aligned.
2. Attach one (1) 3/8" Washer to one (1) 3/8" x 3" Hex
Bolt and insert it into the cradle mount hole. Slip a
3/8" Lock Washer, 3/8" Washer and 3/8" Hex Nut
onto the protruding end of the bolt and hand tighten.
Repeat for remaining cradle.
Figure 2
REQUIRED PARTS
Ladder
QTY: ( 1 )
HARDWARE QTY:
3/8" X 2-1/2" Hex
Bolt
3/8" Lock Nut
3/8" Washer
8
Cradle
QTY: ( 2 )
2
2
2