Golden LAUNCH STANDARD Instruction Manual page 10

ATTACH KAYAK BUNKS
NOTE: It is recommended to use more than one person for
this step to ensure the lift stays upright at all times.
1. Align the two (2) holes in each bunk with the
mounting holes in each cradle as shown in Figure 4.
NOTE: Ensure the rubber side of the Bunks are oriented
upward.
2. Attach one (1) 3/8" Washer to one (1) 3/8" x 2-1/2" Hex
Bolt and insert it into the top of the Bunk and through
the Cradle. Slip a 3/8" Lock Washer, 3/8" Washer and
3/8" Hex Nut onto the protruding end of the bolt and
hand tighten. Repeat three more times.
Figure 4
REQUIRED PARTS
Kayak Bunk
QTY: ( 2 )
10
HARDWARE QTY:
3/8" x 4" Carriage 4
Bolt
3/8" Hex Nut 4
3/8" Lock Washer 4
3/8" Washer 4