Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZCG92246
Summary of Contents for Zanussi ZCG92246
- Page 1 User Manual Cooker ZCG92246 ZCG92286 ZCG92296...
-
Page 2: Table Of Contents
Cleaning and user maintenance shall not be made by children • without supervision. General Safety Only a qualified person must install this appliance and replace • the cable. Do not operate the appliance by means of an external timer or • separate remote-control system. www.zanussi.com... -
Page 3: Safety Instructions
Always wear door or the window is opened. safety gloves. • Do not pull the appliance by the handle. • The kitchen cabinet and the recess must have suitable dimensions. www.zanussi.com... - Page 4 • This appliance is not connected to a device, – do not put water directly into the hot which evacuates the products of appliance. combustion. Make sure to connect the www.zanussi.com...
- Page 5 • Keep children away when the grill is in use. Authorised Service Centre. • Do not put the oven shelf with food on the • Be careful when you remove the door from highest shelf level. the appliance. The door is heavy! www.zanussi.com...
-
Page 6: Product Description
Hob integrated ignition on the control knob Hob ignition on the spark generator button Oven integrated ignition on the control knob Oven ignition on the spark generator button Hob thermocouple Oven thermocouple Enamel Oven clean- Catalytic Enamel Pan support Cast iron www.zanussi.com... - Page 7 Turnspit hole Shelf positions Illustration 2 Button for the turnspit Button for the spark generator Knob for the Minute Minder Knob for the oven functions Button for the lamp Knobs for the hob Grill Lamp Turnspit hole Shelf positions www.zanussi.com...
-
Page 8: Before First Use
Let the oven cool down. Dampen a soft cloth with warm water and a little mild washing-up Preheating liquid and use this to clean the oven cavity. Preheat the empty appliance to burn off the remaining grease. Hob - Daily use WARNING! Refer to Safety chapters. www.zanussi.com... - Page 9 D) Thermocouple (if applicable) If after some tries the burner does Turning the burner off not light, check if the crown and its cap are in the correct position. To put the flame out, turn the knob to the off position www.zanussi.com...
-
Page 10: Hob - Hints And Tips
• Remove immediately: melted plastic, plastic foil, and food with sugar. If not, the dirt can cause damage to the hob. • Remove when the hob is sufficiently cool: limescale rings, water rings, fat stains, shiny metallic discoloration. Clean the hob www.zanussi.com... -
Page 11: Oven - Daily Use
• For integrated ignition on the control When using the oven the lid has to knob turn the knob for the oven be opened to avoid over-heating. functions counterclockwise to the maximum heat settings and push it to light the burner. www.zanussi.com... - Page 12 3. Turn the knob for the oven functions to set the oven functions and turn it to the Off the necessary heat setting. Control the flame trough the holes in the bottom of the oven. www.zanussi.com...
-
Page 13: Oven - Using The Accessories
Put the tray or deep pan on the shelf position. 3. Snap out one end of the support hook from Make sure it does not touch the back wall of the the oven ceiling A and let it hang on the oven. other end. www.zanussi.com... -
Page 14: Oven - Hints And Tips
With this system you can cook in a Baking steamy environment and keep the food soft • Your oven can bake or roast differently to the inside and crusty outside. It decreases the appliance you had before. Adapt your usual www.zanussi.com... - Page 15 4.0 - 4.5 40 - 45 Kebab Hala 3.5 - 4.0 40 - 45 1) Preheat the oven for 15 minutes. Meat & Poultry Food Quantity (kg) Thermostat Time (min) Shelf position position Sheep 3.0 - 4.0 90 - 120 www.zanussi.com...
- Page 16 1) Preheat the oven for 15 minutes. Cakes Food Quantity (kg) Thermostat Time (min) Shelf position position Flat cake 1.2 - 1.5 25 - 30 Flat cake 2.4 - 3.0 30 - 35 2 and 4 Sponge cake 3.0 - 3.5 90 - 100 www.zanussi.com...
-
Page 17: Oven - Care And Cleaning
Fat accumulation or other food remains may Notes on cleaning result in a fire. • Clean the front of the appliance with a soft • Clean stubborn dirt with a special oven cloth with warm water and a cleaning agent. cleaner. www.zanussi.com... - Page 18 5. Use a screwdriver to remove 2 screws from 2. Set the oven temperature to 250 °C and let bottom edge of door. the oven operate for 1 hour. 3. When the appliance is cool, clean it with a soft and moist sponge. www.zanussi.com...
-
Page 19: Troubleshooting
There is no spark when you try to The hob is not connected to an Check if the hob is correctly con- activate the spark generator. electrical supply or it is connec- nected to the electrical supply. ted incorrectly. Refer to the connection diagram. www.zanussi.com... - Page 20 The rating plate is on the front If you cannot find a solution to the problem frame of the appliance cavity. Do not remove yourself, contact your dealer or an Authorised the rating plate from the appliance cavity. Service Centre. www.zanussi.com...
-
Page 21: Installation
Technical data For minimal distances for fitting check the table. Dimension Height 850 - 870 Width Depth Appliance class Other technical data Appliance category: II2H3B/P LPG: G30 (3B/P) 28-30 mbar Natural Gas: G20 (2H) 20 mbar www.zanussi.com... - Page 22 You can connect the gas supply to either one of pipes, make sure they do not come in touch them. The pipe that is not used must be with mobile parts and they are not squeezed. clogged with the pipe closer, which added to the appliance. www.zanussi.com...
- Page 23 To check the seal use a soap solution, not a flame. 4. Replace injectors with the ones necessary for the type of gas you use. The gas supply ramp is on the rear side of the control panel. www.zanussi.com...
- Page 24 1. Fully tighten the bypass screw. 2. Put the knob back. Changing from liquid gas to natural gas 1. Unscrew approximately one turn the bypass screw position A. 2. Put the knob for the hob back. 3. Connect the appliance to the electricity. www.zanussi.com...
- Page 25 4. Release the burner injector with a 7 mm socket spanner and replace it with a right one. Changing from natural gas to liquid gas 1. Fully tighten the bypass screw. 2. Put the knob back. 3. Connect the appliance to the electricity. www.zanussi.com...
- Page 26 2. Put the appliance on the sidewall on a clean and smooth surface. Place each foot into a 2. Release the burner injector with a 7 mm separate hole, in the plinth, and rotate it socket spanner and replace it with a right counterclockwise. one. www.zanussi.com...
- Page 27 Return the product to your the packaging in applicable containers to local recycling facility or contact your municipal recycle it. Help protect the environment and office. human health and to recycle waste of electrical and electronic appliances. Do not dispose www.zanussi.com...
- Page 28 www.zanussi.com/shop...